Champion Canopies & Tarps | Support | Canopy Assembly Instructions

Canopy Assembly Instructions

Our premium canvas tarps are manufactured with rugged woven canvas that's Canvak treated to resist the affects of outdoor exposure. All hems and seams are double stitched while having Four-Ply fabric to reinforced the corners & grommets for maximum durability. Water repellant, breathable, and mildew resistant. Solid brass grommets approx. every 3 ft.

Please note: Tarps do not include bungee balls.

Assembly Instructions: Step 1

The 78-inch leg height is only a recommended height and this can vary if you like. The 118 inch tubing makes the length, and the tubing running up to the peak will vary depending on the width of the canopy purchased. Be sure to secure the unit to the ground. The canopy shouldn't be taken down in heavy winds.

Assembly Instructions: Step 2

Lie out fixtures and tubing and slide top frame together. The washer will be on the inside. Straight side runs parallel to the ground while the curved part goes to the leg and up to the peak.

Assembly Instructions: Step 3

Lay the tarp over the frame and bungee the tarp to the frame.

Assembly Instructions: Step 4

For some valance canopies, the rope and ball go on the side going up to the peak. On others, the side with the three grommets in the middle of the valance section will be at the peak.

Assembly Instructions: Step 5

For Valance Canopies the ball of the bungee should be down to allow the valance to lay over the frame properly.

Assembly Instructions: Step 6

Raise up one side and insert the legs. Repeat on opposite side. When the canopy is free standing and in the proper position, fasten the canopy to the ground by inserting an anchor in the ground and running a strap or rope from the washer at the top of the leg to the anchor. Each leg should be anchored down.

Assembly Instructions: Step 7