Champion Canopies & Tarps
Sales & Technical Assistance: (856) 686-9515
Business & Rental Office: (856) 795-6248
Canopy Assembly Instructions
|
The 78-inch leg height is only a recommended height and this can vary if you like. The 118 inch tubing makes the length, and the tubing running up to the peak will vary depending on the width of the canopy purchased. Be sure to secure the unit to the ground. The canopy should be taken down in heavy winds |
|
Lie out fixtures and tubing and slide top frame together. The washer will be on the inside. Straight side runs parallel to the ground while the curved part goes to the leg and up to the peak. |
|
Lay the tarp over the frame, and bungee the tarp to the frame. |
|
For some Valance Canopies, the rope and ball go on the side going up to the peak. On others, the side with the three grommets in the middle of the valance section will be at the peak. |
|
For Valance Canopies the ball of the bungee should be down to allow the valance to lay over the frame properly. |
|
Raise up one side and insert the legs. Repeat on opposite side. When the canopy is free standing and in the proper position, fasten the canopy to the ground by inserting an anchor in the ground and running a strap or rope from the washer at the top of the leg to the anchor. Each leg should be anchored down. |
|
Valance Canopies can have walls added to the sides to completely enclose the structure from the outside elements. |
|
Champion Canopies & Tarps |